Stand-alone floor rack features two parts--an exterior cabinet and an interior rollout/rotating rack that can be completely disengaged for shop wiring. Fully welded 16-gauge steel with 14-gauge base, reinforced at all load-bearing junctions.
SPECIFICATIONS
Rack Space: 24U
Height (Exterior Cabinet): 53.86 in.
Width (Exterior Cabinet): 24.00 in.
Depth (Exterior Cabinet): 32.875 in. (26.00 usable)
FEATURES: Exterior Cabinet
Configurable top with 10U opening (solid closure panels included)
Welded sides with vents
Open front and back (optional door and rear access cover)
Open base
Green ground wire (cabinet to interior rack)
Three lacing panels
Side supports for optional accessories
Pilot Point screws with captive washers
Provisions for anchoring
Beveled corners
Black wrinkle powder epoxy finish
FEATURES: Interior Pull-out Rack
50.11 in. H (24U)
24 in. D (26 in. useable allows equipment to extend 2 in. beyond rack)
Maximum rollout 25.00 in. (57.875 in. overall rollout depth)
Corner post mounting rails tapped 10-32 with RU increments marked
Inner platform base with casters and stainless steel ball transfers
Three lacing panels
Load capacity 750 lbs.
Installation: Allow 3.5 in. minimum clearance on both sides for rotation
COMPLIANCE & CERTIFICATION
EIA/TIA compliant
RoHS compliant
Certified U.S. steel
Made in Missouri, U.S.A.
A&E SPECIFICATIONS
The two-part host style rack shall be Lowell Model No. LHR-2432 which shall be made in the U.S.A. with certified U.S. steel and have overall measurements of 53.86"H x 24.00"W x 32.875"D with panel space of 24 rack units and useable depth of 26.00". It shall be comprised of an external welded steel cabinet and an internal pull-out rack that is connected to an inner platform caster base with stainless steel ball transfers capable of supporting 750 lbs. The external cabinet shall have vented sides, open front, open back, three rear lacing panels, 10U EIA top opening with solid closure panels, and top knockouts for conduit and wireless antennas. It shall have a black wrinkle powder epoxy finish, provisions for anchoring, and a ground wire to the internal rack. The internal rack shall be a steel assembly with corner post mounting rails tapped 10-32, three rear lacing panels, and side/rear braces. It shall be mounted to the caster base and pull-out smoothly from the cabinet to provide free rotation to rear connections. The internal rack/caster base assembly shall be capable of disengaging from the external cabinet for shop wiring and testing.
